Scopus İndeksli Yayınlar Koleksiyonu
Permanent URI for this collectionhttps://hdl.handle.net/20.500.12573/395
Browse
Search Results
Article Citation - WoS: 1Citation - Scopus: 1Evaluating the Effects of Design and Manufacturing Parameters on Friction at the Surrogate Skin-3D Textile Interface(Sage Publications Ltd, 2025-10-30) Temel-Cicek, Mevra; Cicek, Umur I.; Lloyd, Alex B.; Johnson, Andrew A.Additive manufacturing (AM) is increasingly employed in the development of 3D-printed wearables, including medical wrist supports, textiles, and protective garments. While the general tribological behavior of 3D-printed components has been widely studied, limited research has focused on the friction behavior of 3D-printed wearables when in contact with human skin, which is a crucial factor for improving wearer comfort by minimizing local skin friction. This study, therefore, investigates the influence of material type, manufacturing technology, and print parameters of 3D-printed textiles on frictional behavior against skin. Specimens were fabricated using three AM technologies: material extrusion (MEX), vat photopolymerization (VATP), and powder bed fusion (PBF). Each technology employed various materials and print parameters, specifically layer thickness (ranging from 0.05 to 0.3 mm) and print orientations (horizontal and vertical). Friction was measured using a custom-built handheld device at the interface between 3D-printed specimens and two surrogate skin models: lorica (representing the dorsal forearm) and silicone (representing the chest). The results revealed that friction was significantly influenced by both layer thickness and print orientation. For MEX specimens, acrylonitrile butadiene styrene, acrylonitrile styrene acrylate, and polycarbonate showed the highest friction, while for VATP, durable resin resulted in the highest friction coefficient. In contrast, PBF specimens exhibited very similar frictional behavior. Regarding layer thickness, higher values consistently resulted in the highest friction coefficients, regardless of manufacturing method or material type. These findings provide valuable insights for designers and engineers seeking to optimize the comfort of 3D-printed wearables, guiding the selection of suitable AM processes and parameters for products intended for direct skin contact.Article Failure Analysis of Fused Deposition Modeling 3D Printed Poly Lactic Acid Polymer(Sage Publications Ltd, 2025-10-04) Yilmaz, Cagatay; Eltahir, Sara Saeed AbdulrahmanAdditive manufacturing, commonly known as 3D printing (AM), has emerged as one of the most transformative technological advances in the last few decades in global manufacturing, as it allows for the production of intricate components without the use of costly molds. Fused Deposition Modeling (FDM) is widely adopted among various AM techniques due to its accessibility and effectiveness. FDM 3D-printed PLA (Poly Lactic Acid) shows a transversely isotopic symmetry similar to laminated composite structures. Therefore, classical lamination theory can be applied to FDM 3D-printed PLA. This study attempts to expand the knowledge by relying on classical lamination theory and several imposed failure theories like maximum stress, Tsai-Hill, Tsai-Wu, and Hashin to determine how FDM 3D printing of PLA fails. We investigate eight different raster orientations (0 degrees, 10 degrees, 15 degrees, 30 degrees, 45 degrees, 60 degrees, 75 degrees, and 90 degrees) and compare the theoretical prediction of strength with experimental findings. With this comprehensive analysis, we are seeking to better understand the failure analysis of FDM 3D printed PLA. The maximum stress, Tsai-Wu, Tsai-Hill, and Hashin failure theories show good agreement with experimental findings for 0 degrees and 90 degrees raster orientations. As the raster orientation shifts from 0 degrees, the discrepancy between experimental results and theoretical predictions increases, peaks at mid-angles, and then decreases, becoming negligible at 90 degrees.