Scopus İndeksli Yayınlar Koleksiyonu
Permanent URI for this collectionhttps://hdl.handle.net/20.500.12573/395
Browse
6 results
Search Results
Article Citation - WoS: 28Citation - Scopus: 29Three-Dimensional Au-Coated Electrosprayed Nanostructured BODIPY Films on Aluminum Foil as Surface-Enhanced Raman Scattering Platforms and Their Catalytic Applications(Amer Chemical Soc, 2017-05-16) Yilmaz, Mehmet; Erkartal, Mustafa; Ozdemir, Mehmet; Sen, Unal; Usta, Hakan; Demirel, GokhanThe design and development of three-dimensional (3D) nanostructures with high surface-enhanced Raman scattering (SERS) performances have attracted considerable attention in the fields of chemistry, biology, and materials science. Nevertheless, electrospraying of organic smalt molecules on low-cost flexible substrates has never been studied to realize large-scale SERS-active platforms. Here, we report the facile, efficient, and low-cost fabrication of-Stable and reproducible Au-coated electrosprayed organic semiconductor films (Au@BDY-4TEBDY) on flexible regular aluminum foil at a large scale (5 cm X 5 cm) for practical SERS and catalytic applications. To this end, a well-designed-acceptor-donor-atceptor-type solution-processable molecular semiconductor, BDY-4T-BDY, developed by our group, is used because of its advantageous structural and electrical properties. The morphology of the electrosprayed organic film changes by solution concentration, and two different 3D morphologies with out-of-plane features are obtained. Highly uniform dendritic nanoribbons with sharp needle-like tips and vertically oriented nanoplates (similar to 50 nm thickness) are achieved when electrospraying solution concentrations of 240 and 253% w/v.(mgimL) are, respectively, used. When these electrosprayed organic films are coated with a nanoscopic thin (30 nm) Au layer, the resulting Au@BDY-4T-BDY platforms demonstrate remarkable SERS enhancement factors up to 1.7 X 10(6) with excellent Raman signal reproducibility (relative standard deviation <= 0.13) for methylene blue over the entire film. Finally, Au@BDY-4T-BDY films showed good catalytic activity for the reduction of 4-nitrophenol to 4-aminophenol with rate constants of 1.3 X 10(-2) and 9.2 X 10(-3) min(-1). Our results suggest that electrospraying of rationally designed organic semiconductor molecules on flexible substrates holds great promise to enable low-cost, solution-processed, SERS-active platforms.Article Citation - WoS: 54Citation - Scopus: 58Proton Conducting Self-Assembled Metal-Organic Framework/Polyelectrolyte Hollow Hybrid Nanostructures(Amer Chemical Soc, 2016-08-29) Sen, Unal; Erkartal, Mustafa; Kung, Chung-Wei; Ramani, Vijay; Hupp, Joseph T.; Farha, Omar K.Herein, a room temperature chemical process to synthesize functional, hollow nanostructures from zeolitic imidazolate framework-8 (ZIF-8) and poly(vinylphosphonic acid) (PVPA) is reported. Syntheses are initiated by physically blending the components a process that is accompanied first by encapsulation of ZIF-8 crystallites by PVPA and then by fragmentation of the crystallites. The fragmentation process is driven by partial displacement of the methyl-imidazolate ligands of Zn(II) in ZIF-8 by phosphonate groups on PVPA. Differences in rates of diffusion for the components of the reactive mixture yield a Kirkendall-like effect that is expressed as a hollow-particle morphology. The obtained hollow nanostructures feature hybrid shells containing PVPA, ZIF-8, and their cross-reacted products. The hybrid structures display substantial proton conductivities that increase with increasing temperature, even under the anhydrous conditions prevailing at temperatures above the boiling point of water. For example, at T = 413 K the proton conductivity of ZIF-8@PVPA reaches 3.2 (+/- 0.12) x 10(-3) S cm(-1), a value comparatively higher than that for PVPA (or ZIF-8) in isolation. The high value may reflect the availability in the hybrid structures of free (and partially free), amphoteric imidazole species, and their hydrogen-bonding interactions with phosphonate and/or phosphonic acid units. The persistence of ample conductivity at high temperature reflects the elimination of phosphonic acid group dehydration and dimerization-an effect that strikingly degrades the conductivity of pure PVPA under anhydrous conditions.Article Citation - WoS: 18Citation - Scopus: 21Poly(Lauryl Methacrylate)-Grafted Amino-Functionalized Zirconium-Terephthalate Metal-Organic Framework: Efficient Adsorbent for Extraction of Polycyclic Aromatic Hydrocarbons from Water Samples(Amer Chemical Soc, 2020-05-20) Tabatabaii, Maryam; Khajeh, Mostafa; Oveisi, Ali Reza; Erkartal, Mustafa; Sen, UnalIn this study, a novel porous hybrid material, poly(lauryl methacrylate) polymer-grafted UiO-66-NH2 (UiO = University of Oslo), was synthesized for efficient extraction of polycyclic aromatic hydrocarbons (PAHs) from aqueous samples. The polymer end-tethered covalently to the MOF's surface was synthesized by surface-initiated atom transfer radical polymerization, revealing a distinct type of morphology. The adsorbent was characterized by scanning electron microscopy, energy-dispersive spectroscopy, transmission electron microscopy, powder X-ray diffraction, N-2 adsorption-desorption analysis, Fourier transform infrared spectroscopy, and thermogravimetric analysis. The analyses were carried out by gas chromatography-mass spectrometry. Parameters including the type and volume of the eluent, the amount of the adsorbent, and adsorption and desorption times were investigated and optimized. Under optimal conditions, the limit of detection, intraday precision, and interday precision were in the range of 3-8 ng L-1, 1.4-3.1, and 4.1-6.5%, respectively. The procedure was used for analysis of PAHs from natural water samples.Article Citation - WoS: 7Citation - Scopus: 8Enhancing the Properties of Yttria-Stabilized Zirconia Composites With Zeolitic Imidazolate Framework-Derived Nanocarbons(Amer Chemical Soc, 2023-12-09) Cakan, Niyaz; Issa, Abduselam Abubeker; Alsalman, Hamza; Aliyev, Emin; Duden, Enes Ibrahim; Gurcan Bayrak, Kubra; Sen, UnalCeramic matrix composites (CMCs) reinforced with nanocarbon have attracted significant interest due to their potential to enhance mechanical, thermal, and electrical properties. Although the investigation of carbon-based materials such as graphene and carbon nanotubes as additives for advanced ceramics has been widespread, the utilization of metal-organic framework (MOF)-derived nanocarbons in CMCs remains largely unexplored. We extended our previous proof-of-concept investigations by demonstrating the effectiveness of a different type of MOF-derived carbon as a reinforcing phase in an alternative ceramic matrix. We employed spark plasma sintering (SPS) to consolidate yttria-stabilized zirconia (YSZ) and zeolitic imidazolate framework (ZIF-67) powder blends at 1300 degrees C and a uniaxial pressure of 50 MPa. YSZ serves as the ceramic matrix, whereas ZIF-67 serves as the nanocarbon source. The composite exhibits a highly significant improvement in fracture toughness with an increase of up to 13% compared to that of the YSZ monolith. The formation of ZIF-derived nanocarbon interlayers is responsible for the observed enhancement in ductility, which can be attributed to their ability to facilitate energy dissipation during crack propagation and inhibit grain growth. Furthermore, the room-temperature electrical conductivity of the sintered samples demonstrates a substantial improvement, primarily due to the in situ formation of nanocarbon-based fillers, reaching an impressive 27 S/m with 10 wt % ZIF-67 content. Based on the results, it can be inferred that the incorporation of in situ MOF-derived nanocarbons into CMCs leads to a substantial improvement in both the mechanical and electrical properties.Article Citation - WoS: 16Citation - Scopus: 17Boosting the Ceramics With in Situ MOF- Derived Nanocarbons(Amer Chemical Soc, 2023-04-23) Duden, Enes Ibrahim; Bayrak, Kubra Gurcan; Balkan, Mert; Cakan, Niyaz; Demiroglu, Arsen; Ayas, Erhan; Sen, Unal; Gurcan Bayrak, KubraMetal-organic framework (MOF)-derived nano-carbons have emerged as promising materials for energy and environmental applications owing to their high surface area, structural and chemical tunability, and hierarchical porosity. Although various carbon-based materials such as graphene and carbon nanotubes have been extensively used as secondary sintering additives to develop advanced ceramics with improved mechanical, thermal, and electrical properties, the potential of MOF-derived nanocarbon-based materials has not been ex-plored. Here, we report the first use of MOF-derived nanocarbons as a reinforcement phase in ceramic composites. To this end, Al2O3 and zeolitic imidazolate framework (ZIF-8) are used as the ceramic matrix and nanocarbon source, respectively. The ceramic composites are produced by densifying Al2O3 and ZIF-8 powder mixtures using spark plasma sintering (SPS) at 1550 degrees C and uniaxial pressure of 50 MPa. The fracture toughness of the composite increases up to 67% in comparison to an alumina monolith as ZIF-derived nanocarbons form interlayers to assist the dissipation of energy during the crack propagation and inhibit grain growth. The room-temperature electrical conductivity of the sintered samples drastically increases with the in situ formed nanocarbon-based fillers, reaching as high as 1410 S/m for 10 wt % ZIF-8 content. These results constitute an excellent initial step toward boosting the mechanical and electrical properties of ceramic matrix composites with in situ MOF-derived nanocarbons.Article Citation - WoS: 44Citation - Scopus: 46Boronic Acid Moiety as Functional Defect in UiO-66 and Its Effect on Hydrogen Uptake Capacity and Selective Co2 Adsorption: a Comparative Study(Amer Chemical Soc, 2017-12-29) Erkartal, Mustafa; Sen, UnalHerein, we use linker fragmentation approach to introduce boronic acid moieties as functional defects into Zr-based metal organic frameworks (MOFs, UiO-66). Our findings show that the amount of permanently incorporated boronic acid containing ligand is directly dependent on the synthesis method. The accessible boronic acid moieties in the pore surfaces significantly improve the hydrogen uptake values, which are 3.10 and 3.44 wt % at 21 bar, 77 K for dimethylformamide (DMF)/H2O and DMF/HCI synthesis methods, respectively. Also, CO2 selectivity of the resulting MOFs over N-2 and CH4 significantly increases due to the quadrupolar interaction between active surfaces and CO2 molecules. To the best of our knowledge, both hydrogen storage and selectivity of CO2 for UiO-66 are the highest reported values in the literature to date. Furthermore, another striking result that emerged from the high-pressure hydrogen uptake isotherms is the direct correlation between the defects and hysteric adsorption behavior, which may result in the shift from rigidity to flexibility of the framework due to the uncoordinated sites.