WoS İndeksli Yayınlar Koleksiyonu
Permanent URI for this collectionhttps://hdl.handle.net/20.500.12573/394
Browse
2 results
Search Results
Conference Object Citation - WoS: 17Citation - Scopus: 21Sol-Gel Applications for Ceramic Membrane Preparation(Amer Inst Physics, 2017) Erdem, I.Ceramic membranes possessing superior properties compared to polymeric membranes are more durable under severe working conditions and therefore their service life is longer. The ceramic membranes are composed of some layers. The support is the layer composed of coarser ceramic structure and responsible for mechanical durability under filtration pressure and it is prepared by consolidation of ceramic powders. The top layer is composed of a finer ceramic micro-structure mainly responsible for the separation of components present in the fluid to be filtered and sol-gel method is a versatile tool to prepare such a tailor-made ceramic filtration structure with finer pores. Depending on the type of filtration (e.g. micro-filtration, ultra-filtration, nano-filtration) aiming separation of components with different sizes, sols with different particulate sizes should be prepared and consolidated with varying precursors and preparation conditions. The coating of sol on the support layer and heat treatment application to have a stable ceramic micro-structure are also important steps determining the final properties of the top layer. Sol-gel method with various controllable parameters (e.g. precursor type, sol formation kinetics, heat treatment conditions) is a practical tool for the preparation of top layers of ceramic composite membranes with desired physicochemical properties.Article Citation - WoS: 1Citation - Scopus: 1Pre-Concentration of Municipal Wastewater Using Flocculation-Assisted Direct Ceramic Microfiltration Process: Optimization of Operational Conditions(Springer int Publ Ag, 2022-10) Ozcan, Ozlem; Sahinkaya, Erkan; Uzal, NigmetDirect ceramic microfiltration (DCMF) is an effective technology to pre-concentrate organic matter (OM) for the subsequent anaerobic energy-recovering processes and a fast, cost-effective, easy treatment process for municipal wastewater. The major problem in DCMF is the rapid fouling of the membrane. In this study, to maximize OM recovery rates and prevent membrane fouling, the DCMF process was alternately paired with dosing of a cationic polyacrylamide (PAM) flocculant and chemically enhanced primary sedimentation (CEPS). The DCMF process tested in three stages: (i) optimization of flocculant concentration (0.5, 1, 1.5, and 2 mg/L PAM) and dosing point, (ii) optimization of operational conditions (pH, filtration/backwash duration, flux, and recovery rate) to control membrane fouling, and (iii) long-term operation of the DCMF process. The influence of PAM dosage points on DCMF fouling behavior was explored, and system operating parameters in terms of OM recovery and TMP change were optimized. The CEPS + DCMF setup was discovered to be a potential option for overcoming fouling. The highest chemical oxygen demand (COD) was 520 +/- 20 mg/L in the concentrated wastewater using CEPS + DCMF experiments for 0.5 mg/L PAM. The highest OM pre-concentration was achieved at 90% recovery rate. After the optimization, COD concentration in the concentrate of the DCMF process reached 822 mg/L for the long-term (20 days) operation. The net potential energy production was calculated as 0.28 kWh/m(3) considering the theoretical COD of 1432 mg/L in the concentrate stream. As a novel approach, the CEPS + DCMF process can be used in place of conventional municipal wastewater treatment processes due to its acceptable OM removal performance, simple operation, small footprint, and potential energy generation.