WoS İndeksli Yayınlar Koleksiyonu
Permanent URI for this collectionhttps://hdl.handle.net/20.500.12573/394
Browse
2 results
Search Results
Article Citation - WoS: 22Citation - Scopus: 26Microstructure and Mechanical Properties of Dense Si3N4 Ceramics Prepared by Direct Coagulation Casting and Cold Isostatic Pressing(Elsevier Science SA, 2022-09) Marulcuoglu, Hande; Kara, FerhatComplex shaped dense Si3N4 ceramics were produced by using direct coagulation casting technique via dispersant reaction method of Si3N4 suspension, followed by gas pressure sintering. The effects of solid content of the suspension, additional cold isostatic pressing of the cast parts, and sintering behaviour and on the mechanical reliability of silicon nitride ceramics were investigated. It was observed that all slurries exhibited rheological properties suitable for casting in the range of 44-50 vol.% solid concentrations. Nevertheless, higher solid concentration suspensions resulted in smaller floc size and thus better green microstructures. Parts shaped by direct coagulation casting at all the solid loadings had relatively low strength and reliability after sintering. However, application of additional cold isostatic pressing to the cast parts increased the strength and, particularly, reliability. Dense Si3N4 ceramics with relative density above 99.5%, average bending strength 760 +/- 39 MPa and Weibull module 23.5 had been obtained with 50 vol.% solids content after DCC + CIP process.Article Citation - WoS: 21Citation - Scopus: 27High-Concentration Carbon Assists Plasticity-Driven Hydrogen Embrittlement in a Fe-High Mn Steel With a Relatively High Stacking Fault Energy(Elsevier Science SA, 2018-02) Tugluca, Ibrahim Burkay; Koyama, Motomichi; Bal, Burak; Canadinc, Demircan; Akiyama, Eiji; Tsuzaki, KaneakiWe investigated the effects of electrochemical hydrogen charging on the mechanical properties of a Fe-33Mn-1.1C austenitic steel with high carbon concentration and relatively high stacking fault energy. Hydrogen pre charging increased the yield strength and degraded the elongation and work-hardening capability. The increase in yield strength is a result of the solution hardening of hydrogen. A reduction in the cross-sectional area by subcrack formation is the primary factor causing reduction in work-hardening ability. Fracture modes were detected to be both intergranular and transgranular regionally. Neither intergranular nor transgranular cracking modes are related to deformation twinning or simple decohesion in contrast to conventional Fe-Mn-C twinning induced plasticity steels. The hydrogen-assisted crack initiation and subsequent propagation are attributed to plasticity-dominated mechanisms associated with strain localization. The occurrence of dynamic strain aging by the high carbon content and ease of cross slip owing to the high stacking fault energy can cause strain/damage localization, which assists hydrogen embrittlement associated with the hydrogen-enhanced localized plasticity mechanism.