Browsing by Author "Gokcek, Oznur Begum"

Now showing 1 - 2 of 2

Arsenic removal by the micellar-enhanced ultrafiltration using response surface methodology
(IWA PUBLISHING, ALLIANCE HOUSE, 12 CAXTON ST, LONDON SW1H0QS, ENGLAND, 2020) Gokcek, Oznur Begum; Uzal, Nigmet; 0000-0002-0912-3459; 0000-0003-1730-2905; AGÜ, Mühendislik Fakültesi, İnşaat Mühendisliği Bölümü
The present research investigates the removal of arsenic (As) from aqueous solutions using micellar-enhanced ultrafiltration (MEUF) by utilizing two different surfactants: benzethonium chloride and dodecyl pyridinium chloride (BCl and DPCl). The impact of the operating variables and maximum removal efficiency were found under different conditions for BCl and DPCl surfactants. The maximum As rejection efficiency for MEUF with BCl and DPCl surfactants is 92.8% and 84.1%, respectively. In addition to this, a statistics-based experimental design with response surface methodology was used for the purpose of examining the impact of operating conditions, including initial pH, initial As concentration (ppb), and surfactant concentration (BCl, mM) in As-removal from aqueous solutions. In the analysis of the experimental data, a second-order polynomial model that was validated by statistical analysis for the BCl surfactant was used. On the basis of the response model created, the removal of As ions was acquired at optimum operating parameters, including the initial As concentration of 150 ppb, surfactant concentration of 5 mM and pH 10 for the BCl surfactant with 92.8% As-removal efficiency.
Investigation of the treatability of pre-coagulated slaughterhouse wastewater using dead-end filtration
(WILEY111 RIVER ST, HOBOKEN 07030-5774, NJ, 2021) Ozdemir, Safiye; Uzal, Nigmet; Gokcek, Oznur Begum; 0000-0002-0912-3459; AGÜ, Mühendislik Fakültesi, İnşaat Mühendisliği Bölümü; Uzal, Nigmet
BACKGROUND In the present study, the performance of the membrane process, one of the advanced treatment methods that can enable the reuse of slaughterhouse wastewater, was evaluated. The wastewater was treated using ultrafiltration (UF) (10, 50 kDa), nanofiltration (NF) (150-300 DA) and reverse osmosis (RO) (500 kDa) membranes alone, and UF + NF, UF + RO membrane combinations at different pressures. In addition to rejection and permeate flux considerations, it was attempted to select the most effective membrane by performing scanning electron microscopy, Fourier transform infrared, contact angle, and atomic force microscopy analyses of the membranes used. RESULTS As a result of the experiments, the highest flux was observed at 5 bar for the 50 kDa UF membrane. When the performances of the sequential application of 10 and 50 kDa UF membranes followed by NF and RO membranes were evaluated, the highest flux was obtained for the sequential application of the 50 kDa UF membrane with the NF membrane as 19.68 and 9.05 L m(-2) h, respectively. CONCLUSION The highest chemical oxygen demand (COD) removal was obtained for the RO membrane at 20 bar as 88.67%, and for the 50 kDa UF + RO sequential application, the COD removal was increased from 70% to 88.67%. (c) 2021 Society of Chemical Industry (SCI).